The Topic and the Instruction Is In the File Please Read It Carefully

Assignment Requirements

 

Case Study: The Training Student:

Project leader Bruce Barton was being sorely pressed to complete the development of several engineering prototypes for a field test of a new appliance model for the XYZ company. One particular plastic component of the new model had given difficulty in laboratory tests as it failed repeatedly before reaching the stress level necessary for successful operation. Bruce had directed a redesign of the component using a tough new engineering plastic recommended by the Research Laboratory’s Material Science Department. Stress tests needed to be run on the redesigned component, but Bruce was running short of time and needed to get on with building the prototype.

Bruce sought out the manager of the Material Science Department for help in running stress tests on samples of the new component. With this assistance he could go ahead with prototype building and conduct the tests concurrently. The prototypes, of course, would not be released to field test until the stress tests on the redesigned component proved its design to be satisfactory.

 

Tom Mason, manager of the Material Science Department, was willing to assist because he knew how critical completion of the development was to XYZ’s future appliance plans. However, this was also a busy time for Tom’s department. So, Tom suggested to Bruce that he could assign the test work to one of the engineering training students. Tom was also coordinator of engineering training students, and he liked to use the training students in demanding situations to give them practical experience. Tom assigned the test work to Jack Jacobs, an engineering training student from the State University who was completing his second work session at XYZ. Jack was familiar with the test equipment and previously had done similar test work. Jack was a good student and his training work had been usually well done. Tom commented to Jack that he would need to work diligently to complete the tests before he had to return to State University.

Jack completed the tests on schedule and turned in a report to Tom indicating the component had successfully passed the stress tests. Upon completion of the test report Jack returned to the university for his next school session. Tom gave Bruce the good news. The prototypes were completed and the field test of these prototypes got underway on schedule.

A few weeks later, Bruce rushed into Tom’s office to tell him that most of the prototypes were out of operation because of a catastrophic failure of the component that had been tested in Tom’s lab. Bruce wanted to discuss the test immediately with Jack; but since Jack had already returned to the university, he and Tom settled for studying Jack’s lab notebook in detail.

After review Tom said, “Bruce, I hate to say it but these data look too good. I know the equipment and there should be more scatter in the measurements Jack took. I think some, if not all, these measurements are in error or they have been faked! At best, Jack probably took a few points and ‘extrapolated’ the rest!”

What ethical issues, if any, does this scenario raise?

Bruce and Tom made plans to run all the tests again. Meanwhile, Tom phoned Dr. Frank Thompson, Training Coordinator at State University, to discuss his fear that Jack had falsified data. In the course of the conversation he asked Dr. Thompson if any effort was made to discuss professional ethics with training students before their first work session and if the importance and value of engineering test results were stressed to these students. Dr. Thompson explained that no specific instruction on professional ethics was given to training students, but all lab courses emphasized the need for accuracy in data taking. Dr. Thompson added that he found it hard to believe that a training student would “fake” data!

Was it appropriate for Tom to discuss his concerns about Jack with the university’s Co-op Coordinator prior to discussing the matter with Jack?

Should Tom have a conversation with Jack about his concerns? If so, what type of conversation should Tom have with Jack when he talks with him? Should he refuse to have Jack return to XYZ as a co-op student?

What comments would you make about the supervision given co-op students at XYZ?

Should State University incorporate into its instruction program some emphasis on professional ethics? If so, what form might this take? If not, why not

The Assignment:

This assignment is designed for the evaluation of all Goals covered in the Course Work (CW) of LSHMN243.

 Case study:

The following case is selected to ensure that the discussion of which will cover all Goals covered in the CW. Read the given case and discuss the following specific points:

a-      Discuss all possible ethical pitfalls, i.e. situations where ethical dilemmas could arise as a result of misunderstanding, lack of management directions or deliberate evasions. To cover this part well you need to frequently refer to the course notes for Goal 1 (Ethics & Professional Practice)

b-      Discuss the way out of the ethical dilemma that is facing the main character in the given case, in terms of one of the ethical theories that are covered in Goal 2 (Ethical Theories), clearly demonstrating how the selected theory could help finding a way out of the ethical dilemma.

c-       Discuss how ethics in the workplace issues that were covered in Goal 3 (Ethics in the Workplace) could explain the reason for how such an ethical dilemma haven arisen in the first place and how such a dilemma could have be avoided.

d-      Discuss how the concepts of professional ethics and corporate responsibility that were covered in Goal 4 (Responsibility in Engineering) could be applied to the given case and how could such concepts help the main character in the given case finding a way out of the given ethical dilemma.

It is important to note that the assessment of the submitted work will be based on the following criterion:

Marks will be awarded based of how much reference the student makes to the class notes as well as to outside sources. Using their own words, students should make clear and frequent reference to the course notes, as well as to other resources from Internet or library. The aim of this assignment is to give students the opportunity to demonstrate the depth of their thinking when discussing the given topic, demonstrating the value of what they have learned during the course.

 Plagiarism:

All submitted assignments will be sampled for plagiarism from internet sources using the SafeAssign software. All completed assignments are to be submitted using the BalckBoard Vista SafeAssign. As you already know, plagiarism could result in your expulsion from the HCT as well as the higher education system in the UAE. If you have to use the internet or other resources, cite the exact page reference.

Guidelines for Writing the Assignment:

a-      Criteria for writing a good essay:

• Discuss the given case making frequent reference to the course notes to analyze the issue.
• Apply concepts and theories from the course to the discussion of the given case and the ethical dilemma it raises
• Show evidence of reading more than the course notes
• Show good understanding of key concepts and ideas

 

 

Order Now

http://zelessaywritings.com/order/

 

You can place an order similar to this with us. You are assured of an authentic custom paper delivered within the given deadline besides our 24/7 customer support all through.

 

[order_calculator]